Telit Wireless Solutions LN940A11 SERIES - AT&F Reset at Command Settings to Factory Default Values; ATZ Restore at Command Settings from User Defined Profile

80591ST10886A Rev.2 Page 25 of 200 2018-07-02
1
XON/XOFF filtered
[2]
C105 (RTS) (factory default)
3
XON/XOFF not filtered
< by_ta > Flow control option for the data sent by modem
0
flow control None
1
XON/XOFF
[2]
C106 (CTS) (factory default)
4.12. ATZ Restore AT Command Settings from User Defined Profile
First ATZ resets the AT command settings to their factory default values, similar to AT&F. Afterwards the AT
command settings are restored from a user defined profile in non-volatile memory, if one was stored with AT&W
before. Any additional AT command on the same command line may be ignored. A delay of 300 ms is required
before next AT command is sent.
However, ATZ does not change the current bit rate of asynchronous serial interface (UART).
Syntax
Type
Command
Possible Return Result
Instruction
Exec Command ATZ[<value>] OK -
Parameter Description
parameter
Value
Instruction
<value> [0] User Profile Number
4.13. AT&F Reset AT Command Settings to Factory Default Values
AT&F resets AT command settings to their factory default values.
However, the command does not change the current bit rate of asynchronous serial interface (UART).