80591ST10886A Rev.2 Page 108 of 200 2018-07-02
<mode> [0] message types specified in <mids> and <dcss> are
accepted.
1
message types specified in <mids> and <dcss> are not
accepted.
<mids> - String type, all different possible combinations of CBM
message identifiers.
<dcss> - String type; all different possible combinations of CBM data
coding schemes(default is empty string)
12.8.
AT+CNMI New Message Indications to TE
The command is used to select the procedure how receiving of new messages from the network is indicated to
the TE when TE is active, e.g. DTR signal is ON. If TE is inactive (e.g. DTR signal is OFF). If set <mt>＝2,
<mt>＝3 or <ds>＝1, make sure <mode>＝1, otherwise it will return error.
Syntax
AT+CNMI=? +CNMI: (list of supported
<mode>s),(list of supported
<mt>s),(list of supported
<bm>s),(list of supported
<ds>s),(list of
supported <bfr>s)
AT+CNMI? +CNMI:<mode>,<mt>,<bm>,
<ds>,<bfr>
OK
Write Command AT+CNMI=[<mode>[,<mt
>[,<bm>[,<ds>[,<bfr>]]]]]
OK
Parameter Description
To Next Page
Loading...
Need help?
General
