80591ST10886A Rev.2 Page 90 of 200 2018-07-02
10.12.
AT+CGEREP Packet Domain Event Reporting
The set command enables or disables sending of unsolicited result codes, +CGEV: XXX from MT to TE in the
case of certain events occurring in the Packet Domain MT or the network. <mode> controls the processing of
unsolicited result codes specified within this command. <bfr> controls the effect on buffered codes when
<mode> 1 or 2 is entered. If a setting is not supported by the MT, ERROR or +CME ERROR: is returned.
The read command returns the current mode and buffer settings.
The test command returns the modes and buffer settings supported by the MT as compound values.
Syntax
Test Command AT+ CGEREP=? +CGEREP: (0-2),(0-1)
OK
-
Read Command AT+ CGEREP? +CGEREP: 0,0
OK
-
Write Command AT+ CGEREP=[<mode>[,<bfr>]] OK -
Parameter Description
<mode> 0
Buffer unsolicited result codes in the MT; if MT result code buffer is full, the
oldest ones can be discarded. No codes are forwarded to the TE.
1
Discard unsolicited result codes when MT-TE link is reserved (e.g. in on-line
data mode); otherwise forward them directly to the TE.
2
Buffer unsolicited result codes in the MT when MT-TE link is reserved (e.g. in
on-line data mode) and flush them to the TE when MT-TE link becomes
available; otherwise forward them directly to the TE.
<bfr> 0
MT buffer of unsolicited result codes defined within this command is cleared
when <mode> 1 or 2 is entered
To Next Page
Loading...
Need help?
General
