Telit Wireless Solutions LN940A11 SERIES User Manual

80591ST10886A Rev.2 Page 30 of 200 2018-07-02
OK
4.20. ATS2 Escape Character
The command sets the ASCII character to be used as escape character.
Syntax
Type
Command
Possible Return Result
Instruction
Read Command ATS2? <value>
OK
-
Write Command ATS2=[value] OK -
Parameter Description
parameter
Value
Instruction
<value> 1-255 43(+) is default value
4.21. ATS7 Connection Completion Time-Out
This set command sets the amount of time, in seconds, that the device shall allow between either answering a
call (automatically or by A command) or completion of signaling of call addressing information to network
(dialing), and establishment of a connection with the remote device.
Syntax
Type
Command
Possible Return Result
Instruction
Read Command ATS7? <value>
OK
-
Write Command ATS7=[value] OK -
Parameter Description

Telit Wireless Solutions LN940A11 SERIES Specifications

General

Brand	Telit Wireless Solutions
Model	LN940A11 SERIES
Category	Control Unit
Language	English