80591ST10886A Rev.2 Page 78 of 200 2018-07-02
<precedence> 1-3
A numeric parameter which specifies the precedence class.
<delay> 1-4
A numeric parameter which specifies the delay class.
<reliability> 1-5
A numeric parameter which specifies the reliability class.
<peak> 1-4
A numeric parameter which specifies the peak throughput class.
<mean> 1-18,31
A numeric parameter which specifies the mean throughput class.
10.5.
AT+CGQMIN Quality Of Service Profile (Minimum acceptable)
This command allows the TE to specify a minimum acceptable profile which is checked by the MT against the
negotiated profile returned in the Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the (local) context identification parameter,
<cid>. Since this is the same parameter that is used in the +CGDCONT and +CGDSCONT commands, the
+CGQMIN command is effectively an extension to these commands. The QoS profile consists of a number of
parameters, each of which may be set to a separate value.
A special form of the set command, +CGQMIN= <cid> causes the minimum acceptable profile for context
number <cid> to become undefined. In this case no check is made against the negotiated profile.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
Syntax
Test Command AT+ CGQMIN =? +CGQMIN: “IP”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQMIN: “PPP”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQMIN: “IPV6”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQMIN: “IPV4V6”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
-
Read Command AT+ CGQMIN? +CGQMIN:
OK
-
Write Command AT+ CGQMIN =[<cid>
[,<precedence > [,<delay>
OK -
To Next Page
Loading...
Need help?
General
