80591ST10886A Rev.2 Page 122 of 200 2018-07-02
Null
13.3.
AT$QCTER Set TE-DCE Baud Rate
AT$QCTER command is used to set TE-DCE baud rate. Sets the TE-DCE rate at which DCE will accept
commands; this data rate also becomes the default and is stored in NV RAM, changing the +IPR command
default rate. Test command, i.e., $QCTER=?, returns the rates supported and query command, i.e.,
$QCTER?, returns the rate last issued by the $QCTER command or the default rate.
Syntax
Test Command AT$QCTER=?
$QCTER: (),(list of supported
<rate>)
Read Command AT$QCTER? $QCTER: <rate>
OK
Write Command AT$QCTER=<rate> OK
Parameter Description
<rate>
300,600,1200,2400,4800,96
00,19200,38400,57600,1152
00,230400,921600,2000000,
2900000,3000000,3200000,
3686400,4000000
13.4.
AT$QCDNSP Set Primary DNS IP ADDR
AT$QCDNSP command is used to set primary DNS IP address.
Syntax
To Next Page
Loading...
