Telit Wireless Solutions LN940A11 SERIES - AT+CSDH Show Text Mode Parameters

80591ST10886A Rev.2 Page 106 of 200 2018-07-02
12.6. AT+CSDH Show Text Mode Parameters
The command is used to control whether detailed header information is shown in text mode result codes.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command
AT+CSDH=? +CSDH: (list of supported <show>s)
Read Command
AT+CSDH? +CSDH: <show>
Write Command AT+CSDH=[<show>] OK
Parameter Description
parameter
Value
Instruction
<show> 0 Do not show header values defined in commands AT+CSCA
and AT+CSMP (<sca>,<tosca>, <fo>, <vp>, <pid> and
<dcs>) nor <length>, <toda> or <tooa> in+CMT, AT+CMGL,
AT+CMGR result codes for SMS-DELIVERs and SMS-
SUBMITs intext mode; for SMS-COMMANDs in AT+CMGR
result code, do not show <pid>, <mn>, <da>, <toda>,
<length> or <data>
1
Show the values in result codes
Example
at+cmgw=”18576408172”
> rose hello
+CMGW: 0
OK
at+cmgl=”all”
+CMGL: 0,”STO UNSENT”,”18576408172”,,,129,10
rose hello
at+csdh=1
In index 0, restore a message
Show this message
Set Text Mode Parameters