80591ST10886A Rev.2 Page 76 of 200 2018-07-02
Write Comm
and
AT+ CGTFT =[<
cid>, [<packet
filter identifier>
, <e
valuation
precedence index> [,<source address and subnet mask>
[,<protocol number (ipv4) / next header (ipv6)> [,<destination port
range> [,<source port range> [,<ipsec security parameter index
(spi)> [,<type of service (tos) (ipv4) and mask / traffic class (ipv6)
and mask> [,<flow label (ipv6)> ]]]]]]]]]
OK -
Parameter Description
<cid> 1-24
A numeric parameter which specifies a particular PDP context definition (see
the +CGDCONT and +CGDSCONT commands).
<packet filter identifier> 1-2
-
<evaluation precedence
index>
0-255
-
<source address and
subnet mask>
-
0.0.0.0.0.0.0.0 to 255. 255. 255. 255. 255. 255. 255. 255
‘a1.a2.a3.a4.m1.m2.m3.m4’, for Ipv4,
‘a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a15.a16.
m1.m2.m3.m4.m5.m6.m7.m8.m9.m10.m11.m12.m13.m14.m15.m16’, for
Ipv6.
<protocol number (ipv4) /
next header (ipv6)>
0-255
-
<destination port range> -
0.0 to 65535.65535
Consists of dot-separated numeric (0-65535) parameters on the form ‘f.t’.
<source port range> -
0.0 to 65535.65535
Consists of dot-separated numeric (0-65535) parameters on the form ‘f.t’.
<ipsec security parameter
index (spi)>
-
Hexadecimal parameter, value range from 00000000 to FFFFFFFF.
<type of service (tos) (ipv4)
and mask / traffic class
(ipv6) and mask>
-
0.0 to 255.255
Dot-separated numeric (0-255) parameters on the form ‘t.m’.
<flow label (ipv6)> -
Hexadecimal parameter, value range from 00000 to FFFFF.Valid for Ipv6
only
To Next Page
Loading...
Need help?
General
