EasyManua.ls Logo

Telkonet Aida - Maximum Number of Associated Devices; How to Get Support; FCC Compliance Statement

Telkonet Aida
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAXIMUM NUMBER OF ASSOCIATED DEVICES
Aida can accept associations with up to 32 total Telkonet and other compatible wire-
less devices, such as occupancy sensors and door contacts.
HOW TO GET SUPPORT
DURING INSTALLATION
Contact your dedicated Telkonet Project Manager if you have any installation ques-
tions.
AFTER INSTALLATION
Contact the Telkonet Support Center at support@telkonet.com, (414) 302-2203, or the
phone number you were provided at installation, based on your support subscription
plan.
FCC COMPLIANCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential install-
ation. This equipment generates, uses and can radiate radio frequency energy and if
not installed and used in accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
Operation with non-approved equipment is likely to result in interference to radio
and TV reception. The user is cautioned that changes and modifications made to the
equipment without the approval of the manufacturer could void the user's authority
to operate this equipment.
FCC RF Exposure Statement: To comply with FCC RF exposure compliance require-
ments, the device must be installed to provide a separation distance of at least 20 cm
from all persons.
Chapter 1: Overview 2
Aida IOM

Related product manuals