To Next PageTo Next Page
Need help?Do you have a question about the Telkonet ecosmart EcoTouch+ and is the answer not in the manual?
General| Brand | Telkonet |
|---|---|
| Model | ecosmart EcoTouch+ |
| Category | Thermostat |
| Language | English |
Reduces HVAC energy consumption while maintaining occupant comfort.
Details FCC compliance and operational conditions for the device.
Provides best practices and recommendations for optimal thermostat placement.
Details the pin assignments and signals for the J2 connector.
Details the pin assignments and signals for the J3 connector.
Lists the necessary screws and anchors for mounting the device.
Step-by-step guide for physically installing the EcoTouch+ device.
Instructions for connecting power to the J2 connector on the EcoTouch+.
Specifies the required sequence for associating devices in the system.
Guides users through testing Lutron lighting scenes on the EcoTouch+.
Explains how to test communication between EcoTouch+ and Saflok devices.
Outlines the steps to bring the EcoTouch+ thermostat into working condition.
Addresses issues when the occupancy test fails during commissioning.
Provides solutions for HVAC cool or heat mode failures during commissioning.
Instructions for cleaning the device's touchscreen safely and effectively.
Steps for replacing the batteries in the EcoTouch+ battery pack.
Checklist for inspecting the installed components and wiring.
Guide to changing the wireless communication channel for the thermostat.
How to enable and configure display modes like Demo Mode and Display Style.
Explains the information displayed on the System Status screen.
Answers common questions about pairing EcoTouch+ with EcoSource+.
Explains the process for calibrating the proximity sensor.
Addresses problems with the EcoTouch+ screen not dimming correctly.
Lists potential causes and solutions when the HVAC unit does not operate.
Addresses problems related to door or window contact sensors.
Solutions for when the room is too hot or too cold upon occupant return.
How to resolve "Sensor Down" messages on the thermostat.
Diagnosing issues where only one HVAC mode (heat/cool) functions.
Solutions for issues related to the touch screen's responsiveness.
Addresses problems with the MAC address reverting to FFFF during installation.
Explains why the setpoint might not be achieved within RecoveryTime.
Identifies and explains the main controls visible to guests on the thermostat screen.
Describes the sequence to unlock administrative controls using a 3-finger tap.
Details how to access and interpret the three-day weather forecast.
Steps for adjusting the display brightness and dimming settings.
Instructions for changing the display language on the thermostat.
