Install the EcoTouch+
EcoTouch+ IO&M Guide
Telkonet, Inc.
For Use with Firmware Version 2.x
20800 Swenson Drive, Suite 175
Install the EcoTouch+
Waukesha, WI 53186
Revision 5
(414) 302-2299
Page 11
www.telkonet.com
Figure 6-Battery Pack Punch Out
7. Level the backplate on the wall.
8. Battery Version: mark the placement of the battery pack hole using battery pack punch out (again,
see Figure 6).
9. Mark the placement for the mounting screws.
10. Battery Version: cut out a 1.5” x 1.5” hole in the wall where you marked it Step 8.
11. Mount the backplate to the wall using the mounting screws.
12. Battery Version: Insert 4 batteries in the battery pack.
13. Battery version: slide battery pack through the punch out and into the wall (see Figure 7). (Neither
a mounting bracket nor jbox are required.)
Figure 7: Installed Battery Pack (Hidden from View)
To Next Page
Loading...
