OC441665
Release 1. 22jan16jh
This document is TELMA’s property. It cannot be either forwarded to an outsider, printed, reproduced or disclosed without TELMA’s authorization. Page
5 / 23
3. NECESSARY TOOLS
- Protective glasses and gloves
- Handling safety tools for retarder
- Flat screwdriver
- Torx® TX40 wrench
- Click-type wrench
- 10 mm long socket and 17 mm socket
- Tab washer driver
- Hammer
- A feeler gauge
- Magnetic dial gauge and its sensor
- Ink marker
- Torque wrench (torque values : 5.25 and 30 Nm)
- Abrasive cloth (120 grade)
4. PARTS TO BE REPLACED SYSTEMATICALLY
When they have been removed the following parts need to be changed.
- End shaft screws, washers, shims and lock tabs
- Screws used to secure hub
- Screws used to secure retarder fixation pads
- Screws used to secure pole shoes plate
- Air gap adjusting shims
- Line shaft dust shields
5. NOTES
Some parts handled during the maintenance operations are covered with a special product
against corrosion. Take precautions when handling to prevent damage to these protections.
For ease and given the diversity of installations on vehicles, this procedure has been done with
the retarder removed from the vehicle and its accessories (power unit and retarder brackets)
removed from the retarder.
To remove power unit or retarder brackets, please refer to the appropriate procedures.
The different pictures on this procedure are generic views and are not contractual.
To Next Page
Loading...