OC441665
Release 1. 22jan16jh
This document is TELMA’s property. It cannot be either forwarded to an outsider, printed, reproduced or disclosed without TELMA’s authorization. Page
12 / 23
c. REMOVAL OF THE DEFECTIVE HUB
3-A 3-B
3-C 3-D
Screw by hand a screw in the shaft line in
order to facilitate hub removal.
Pull on the screw by hand to help removing the
hub.
When removing hub, be careful not to
damage the coils and internal wiring.
Internal view of retarder without its hub.
Clean the stator in order to remove dust
which could cause bad hub fitting.
Use abrasive cloth (120 grade).
Indexing location for hub vent cap (gearbox side).
To Next Page
Loading...
