What to do if the Telstar Laboratory Equipment display does not turn on?
First, ensure the power cord is securely connected to both the cabinet and the wall socket. Next, verify that the wall socket has power. If these steps don't resolve the issue, a specialized technician should replace the main control.
What to do if the Telstar Laboratory Equipment shows insufficient exhaust flow alarm LOW INFLOW?
If you're seeing a 'LOW INFLOW' alarm, start by visually inspecting the exhaust for any obstructions. Then, check the front perforation in the working area, ensuring it's free from blockage. Also, consider the distance between the cabinet exhaust and the lab ceiling; increasing this space may help. Check the probe position and make sure it is correct.
What to do if the Telstar Laboratory Equipment shows insufficient laminar down flow alarm LOW LAM. FLOW?
If you're getting a 'LOW LAM. FLOW' alarm, start by visually inspecting the front and rear perforation in the work zone for any obstructions. Also, check the probe position to be sure it is correct and remove any obstruction to the probe.
What to do if the Telstar Laboratory Equipment shows excessive laminar down flow alarm HIGH LAM. FLOW?
If the alarm 'HIGH LAM. FLOW' is on, check the probe position to be sure it is correct. Also, check and remove any airflow in front of the cabinet that distorts the reading of the sensor.
What to do if the Telstar Bio II Advance Plus Laboratory Equipment glass is out of position and shows alarm WORK POSITION?
If the alarm 'WORK POSITION' is on, assemble the glass in working position.
What to do if the Telstar Laboratory Equipment open frontal shows alarm WORK POSITION?
If the alarm 'WORK POSITION' is on, slide down the glass to closed position and check that the frontal contacts are not loose and remove any type of obstruction.
What to do if the Telstar Bio II Advance Plus Laboratory Equipment light does not turn on?
Check that the lamp is properly connected and change the led bar.
What to do if the Telstar Bio II Advance Plus UV germicidal lamp does not turn on (optional accessory)?
Check that the front slides properly. Also, check that the lamp holder is connected properly and change the UV lamp. Change the reactance.
Instructions on proper placement and positioning of the cabinet.
Details on power requirements and connection procedures.
Mandatory tests to ensure correct operation after installation.
Step-by-step guide for powering on and initiating the cabinet.
Overview of the control panel interface, functions, and displays.
Details on HEPA filter lifespan, replacement, and handling.
Procedures for routine cleaning of cabinet surfaces.
Verifies the integrity of both downflow and exhaust HEPA filters.
Measures downflow and inflow air velocities and tests alarm set points.
General| Type | Biological Safety Cabinet |
|---|---|
| Filter Type | HEPA H14 |
| Front Opening | 200 mm |
| UV Light | Optional |
| Certification | EN 12469 |
| Work Area Dimensions | 900 mm width |
| Noise Level | < 65 dB(A) |
| Power Supply | 50Hz |
To Next Page
