Telstra TSH-D - Phonebook Management; Storing and Entering Contacts

17
Phonebook
The phone gives you access to 2 phonebooks:
Local contacts - The contacts are saved locally on the phone.
The local phonebook can store up to 100 contacts. Names can be up to 16 characters
Base contacts - The contacts are saved on the modem. All the phones registered to
the modem can access these shared contacts.
and numbers up to 24 digits. The number of contacts in the modem, is dependent on
the modem the phone is registered to.
Every entry contains a rst and last name and up to 3 telephone numbers (e. g.
home, mobile, ofce).
There are 2 ways to enter the phonebooks, either press
directly to the last phonebook accessed, then press
between base and local contacts, or you can go through the phone menu.
Store a name and number
If the phone is connected to a switchboard, you may need to enter a pause in a
number. This gives the switchboard time to nd an outside line. A pause
is normally stored after the s
witchboard access code (e.g. 9). When storing a number,
press and hold 0 until the display shows
P. You can then continue storing the phone
number.
If you wish to display the name of your caller instead of the number, save the full
telephone number including the area code to your phonebook.
Press Menu , Contacts
is displayed, press Select .
Scroll to select the desired phonebook and press Select .
Press Option , Add is highlighted, press Select .
First Name is highlighted, enter the rst name.
Scroll to Last Name , enter the last name.
Scroll to select the number category you want to store the number under,
either
Home , Mobile or Ofce .
Enter the number and press Save
BACK button
BACK button
.
Press to return to standby.
Note
Cancel storing an entry b y pressing at any time during the process.
ENTERING NAMES
Use the alphanumeric keypad to enter names in the phonebook.
For instance to enter the name Paul
P Press
7 once
A Press
2 once
or



PHONEBOOK key to go
PHONEBOOK key to switch