https://wiki.teltonika-gps.com/view/FMB110_First_Start
FMB110 First Start
Main Page > Advanced Trackers > FMB110 > FMB110 First Start
GNSS/GSM/Bluetooth tracker with internal GNSS/GSM antennas
Contents
1 How to insert Micro-SIM card
2 2x6 socket pinout
2.1 PC Connection (Windows)
2.2 How to install USB drivers (Windows)
2.3 Configuration (Windows)
2.4 Quick SMS configuration
3 Mounting recommendations
3.1 Installation photos
4 Safety information
4.1 Precautions
How to insert Micro-SIM card
Gently remove FMB110 cover using plastic pry tool from both sides.1.
Note: To properly open a new case please watch this video.
Insert Micro-SIM card as shown with PIN request disabled or read Security info how to2.
enter it later in Teltonika Configurator. Make sure that Micro-SIM card cut-off corner is
pointing forward to slot.
After configuration, see “PC Connection (Windows)”, attach device cover back.3.
Device is ready to be mounted.4.
Device is ready to be installed.
Micro-SIM card insertion/removal must be performed when device is powered off –
external voltage disconnected. Otherwise Micro-SIM card might be damaged or device
will not detect it.
To Next Page
Need help?
General
