https://wiki.teltonika-gps.com/view/FMB120_First_Start
FMB120 First Start
Main Page > Advanced Trackers > FMB120 > FMB120 First Start
GNSS/GSM/Bluetooth tracker with internal GNSS/GSM antennas and internal battery
Contents
1 How to insert Micro-SIM card and connect the battery
2 Battery placement after complete device disassembling
3 2x6 socket pinout
3.1 PC Connection (Windows)
3.2 How to install USB drivers (Windows)
3.3 Configuration (Windows)
3.4 Quick SMS configuration
4 Mounting recommendations
4.1 Installation photos
5 Safety information
5.1 Precautions
How to insert Micro-SIM card and connect the battery
Gently remove FMB120 cover using plastic pry tool from both sides.1.
Note: To properly open a new case please watch this video.
Insert Micro-SIM card as shown with PIN request disabled or read Security info how to2.
enter it later in Teltonika Configurator. Make sure that Micro-SIM card cut-off corner is
pointing forward to slot.
Connect battery as shown to device. Position the battery in place where it does not obstruct3.
other components.
After configuration, see “PC Connection (Windows)”, attach device cover back.4.
Device is ready to be installed.
Micro-SIM card insertion/removal must be performed when device is powered off –
external voltage and internal battery disconnected. Otherwise Micro-SIM card might be
damaged or device will not detect it.
To Next Page
Need help?
General
