https://wiki.teltonika-gps.com/view/FMB910_First_Start
FMB910 First Start
Main Page > Basic Trackers > FMB910 > FMB910 First Start
Simple and smart tracker with internal backup battery
Contents
1 How to insert Micro-SIM card, connect power supply cable and internal back-up
battery
2 Pinout
2.1 PC Connection (Windows)
2.2 How to install USB drivers (Windows)
2.3 Configuration (Windows)
2.4 Quick SMS configuration
3 Mounting recommendations
4 Installation photos
5 Safety information
5.1 Precautions
How to insert Micro-SIM card, connect power supply cable
and internal back-up battery
Gently remove FMB910 cover using plastic pry tool from both sides.1.
Separate PCB from plastic cover and connect power supply cable.2.
Insert Micro-SIM card as shown with PIN request disabled or read Security info how to3.
enter it later in Configurator. Make sure that Micro-SIM card cut-off corner is pointing
forward to slot.
Connect internal back-up battery.4.
Attach device cover back. (Do not forget to configure the device before reassembling5.
the device!)
Device ready to use!6.
Micro-SIM card insertion/removal must be performed when device is powered off –
external voltage and internal battery disconnected. Otherwise Micro-SIM card might be
damaged or device will not detect it.
To Next Page
Need help?
General
