https://wiki.teltonika-gps.com/view/How_to_debug_Teltonika_device_over_Android_smartphone
How to debug Teltonika device over Android
smartphone
General Technical Questions > How to debug Teltonika device over Android smartphone
Solution applies for these Teltonika devices
TMT250 | GH5200 | TST100 | TFT100
Pair and connect device
Bluetooth starts automatically when device is on. Take your mobile phone, go to Settings->Bluetooth
and turn it on. Scan for nearby devices, find the device in the list, distinguish the device by last IMEI
digits on device module. Press pair, wait until device asks to enter pairing password, type: "5555"
(as in the example on the figure). Paired device will show up in the paired device list. Download a
terminal for Bluetooth, e.g. "Serial Bluetooth Terminal", from Play Store/App store. Run app, click
Find->Connect to your paired device. Now we need to send a command to the device from Bluetooth
terminal, type: ".log:1"
Device will respond with "Log enabled" and the log will show up. Do not forget to save the log file to
mobile phone.
Device debug over Android smartphone
In order to pair the device with Android smartphone, make sure that BT radio is enabled (visible) in
device configuration. It can be checked via SMS command too:
"getparam 800"
The answer has to be "2", which means "Enabled and visible".
To Next Page
Need help?
General
Weight and Dimensions
