A07A2200S
4.6.6 The screen shot for the password request is the following:
To go on, it is essential entering the four numbers which can be known by reading the transmitter
delivery document. If the password is unknown or it is too difficult to open the top cover by
unscrewing the 20 locking screws, it is just possible to surf among the previous screen shots which
give all the information about the transmitter.
4.6.7 By entering the right combination and then ENTER, the first setting of the
transmitter is accessed:
2000 Watt
1500 Watt
In this screen shot i the maximum value of the direct power setting can be changed by the keyboard
with the limit of 1500W; therefore in this screen shot output power can’t be adjusted, but a remedy
is taken to solve a quite common error in the output power adjustment of the exciter-amplifier
systems.
The change and entry of new data may be performed by pressing the horizontal and vertical cursors
and the ENTER button.
4.6.8 Entering instead PAGE UP, the following screen shot is accessed:
110 Watt
100 Watt
380 221 R02 Pag. 19
To Next Page
Loading...