Tempco TEC-2400 - 4 Factory Default Settings

Page 43 of 44
4 Factory Default Settings
The controller parameters can be loaded with default values listed in the parameter
description table. In certain situation it is desirable to retain these values after the parameters values has
been changed. The below procedure to be followed to reload the default values.
1. Ensure the LOCK parameter is set to NONE.
2. Press and hold for 6.2 seconds or until (Hand Control) appears on the
display.
3. Press key to navigate the manual mode menu to reach FILE.
4. Press and hold for 5 seconds or until the upper display FILE flash for a moment.
The default values of all parameters are now loaded.
Notes
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________