TemperZone SAT-2 - Time Functions; Clock and Timer Programming

Page 6
Press
button to activate the air louvre sweep function, or to set the louvre at
a preferred angle.
Time Functions
Setting Clock
a) Press
TIME
or
TIME
button to enter clock set mode, clock symbol
flashes.
b) Press
TIME
or
TIME
button to increase or decrease the clock setting in 1
minute. Hold down the button to change the setting at a faster speed.
c) Press
D
A
Y
button to change the set day.
Setting 7 Day Timer
The timer can be set to turn on and off, two sessions per day, and one regular
session per week.
On or Off Timer Setting
a) Press
TIMER
button to select on timer or off timer. If on timer is selected,
ON
symbol and set day flashing. If off timer is selected,
OFF
symbol and set
day flashing.
b) There are 2 sessions of on or off timer available per day. Press or
button to select session 1 (P1) or session 2 (P2). The selected session is
indicated on the temperature display area as P1 or P2.
c) Press
D
A
Y
button to change the set day of the on or off timer.
d) If the selected timer for the set day is empty, timer display area shows
, otherwise the on or off timer setting will be shown.
e) Press
TIME
or
TIME
button to change the on or off timer setting. Hold down the
button to change the setting at a faster speed.
f) Symbol lights up to indicate there is on or off timer being set.
g) Press
CANCEL
key to cancel the current on or off timer being set, timer display
area shows .
h) Repeat step a) to e) until the desired timer for each session and each day
have been set.
i) System will save and exit timer settings 6 seconds after last key press.
j) In non timer set mode, hold down
CANCEL
key for 5 seconds will cancel all the
on or off or override timer being set.