Operating Procedures Continued
Page 10
Operation
SET-UP, STARTING AND STOPPING
Assuming the previous Pre-Operation instructions have been followed the fan is now
ready to run. Please review the engine manufacturers Owners Manual regarding starting
and stopping as well as the instructions in this section before actually starting the fan.
CAUTION: DO NOT MOVE THE BLOWER WHILE IT IS IN
OPERATION. SEVERE PERSONAL INJURY IS POSSIBLE AS WELL AS
DAMAGE TO THE FAN.
ALWAYS SHUT-DOWN THE FAN PRIOR TO MOVING.
SET-UP
Position the fan in the desired location, making sure it is secure and the immediate sur-
rounding area is free of debris.
STARTING See gure 1 on page 9
1. Set the stop switch/ignition switch to the “ON” position.
2. Set the fuel valve/fuel shuto switch in the “ON” position.
3. Set (if equipped) the choke lever to the “CLOSED” or “STARTING”
position.
4. Set the throttle lever to the 1/2 open position.
5. Grasp the starter handle, take up the slack, and pull the rope briskly. Let the
rope return slowly. Repeat as necessary until the engine starts. Do not over pull the
rope.
6. If equipped with a choke, move the choke lever to the ½ position until the
engine runs smoothly and then to the open or o position.
7. Move the throttle to the desired speed.
STOPPING
1. Move the throttle to the “IDLE” position.
2. Move throttle lever to the “OFF” position unless equipped with a stop
switch. If a stop switch is provided, turn the switch to the “OFF” position.
To Next Page
Loading...