16
syncing two bases (optional)
A Sync Cord is included with Twin Long and Split Cal King size bases.
The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
Disconnect the battery backup box cable from each
control box or splitter cable (make note where the cable
was plugged in).
Plug bases back into the power source.
Tandom mode applies to a sync setup of TXL and CKS
sizes only. When activated, the fan on the base assigned
“left side” will be controlled by the LEFT fan button,
and the fan on the base assigned the “right side” will be
controlled by the right fan button. Please note, all other
remote functions will control both bases simultaneously. To
activate this mode, press and hold the LEFT Fan and SYNC
If bases become mismatched, return both bases to the at
position to re-sync the bases.
Connect the male end of each sync cord to control box
or splitter cable. Insert it into the same port that you
disconnected the battery backup box from in Step 2.
Unplug the base(s) from power source.
Connect each battery backup box male connection to the
sync cord female connection (Refer to illustration at right).
STEP 3
STEP 2
STEP 5
STEP 6
STEP 1
STEP 4
PERFORMANCE NOTES
Battery
Backup
Box 1
Sync Cord
Battery
Backup
Box 2
Control Box 1 Control Box 2
button at the same time. Backlight LED ash (2x) after 6
seconds indicates that Tandem Setup is on.
To Deactivate Tandem Mode and revert the system to normal
setup, press and hold the RIGHT Fan and SYNC button at the
same time. Backlight LED ash (2x) after 6 seconds indicates
that Tandem Setup is off.
Right Side Left Side
To Next Page
Loading...
Need help?
General
