7
Legs are shipped fully assembled. Alternative heights in 3"
increments can be achieved by removing leg segments.
To install the legs, thread the washer over the bolt of the leg
with the recessed side facing the leg, and tighten by hand.
Do not over tighten.
STEP 1
STEP 2
installation guide
Always use two people when setting up the base.
Place the bed base box in a desired location with the
bottom of the box facing up.
Remove the binding straps and packing materials,
making sure not to puncture the box with any sharp
objects.
Remove the bed base from the box keeping the bottom
of the base facing upwards.
STEP 3
STEP 4
STEP 5
STEP 6
Uncoil input power cord (connected
to control box's power port) and
plug into power supply.
If installing a split unit, see page 16.
To install headboard brackets (sold separately), see
instructions on page 17.
Locate the battery backup box
and install (2) 9-Volt batteries (not
included).
(For operating instructions see page
14).
Uncoil the power cord and connect to
the power supply. Place power supply
on the ground and extend from the
base. Ensure that the power supply
and all attached cords are directed
toward the desired surge protector.
For Tempur-Pedic customer service call: U.S. 1-800-821-6621 | Canada: 1-800-887-4321
To Next Page
Loading...
Need help?
General
