To Next PageTo Next Page
Need help?Do you have a question about the Temtrol SERIES ITF and is the answer not in the manual?
General| Brand | Temtrol |
|---|---|
| Model | SERIES ITF |
| Category | Air Conditioner |
| Language | English |
Introduction to the purpose and scope of the instruction manual.
Details the specific model and series of the air handling units.
Defines terms, limitations, and exclusions for warranty claims.
Diagram and instructions for safely lifting and rigging the unit.
Instructions for disassembling or assembling unit segments.
Detailed instructions for sealing roof-mounted demount seams.
Procedures for removing shipping restraints before installation.
Guidance on connecting wiring at demountable sections.
Instructions on removing shipping lock-down bolts.
Guidance on adjusting SS3 hinges for doors.
Covers unit handling, storage, and general installation steps.
Procedures and checks for initial unit operation and verification.
Document for recording start-up checks and parameters.
Checks to verify proper unit operation after start-up.
Checks and cleaning procedures for fan blades and housing.
Guidance on checking and lubricating bearings and shafts.
Details on lubrication intervals and types for fan bearings.
A schedule outlining recommended maintenance tasks and their frequency.
Step-by-step guide for replacing fan wheel and motor assemblies.
Procedure for aligning fan wheels and cones on FWR/FWT units.
Instructions for installing and servicing backdraft dampers on FWR/FWT units.
Procedure for installing and removing blank-off plates on FWR/FWT units.
General inspection and maintenance for FWR/FWT unit motors.
Common fan problems, causes, and solutions.
Addresses issues related to electric heating coil operation.
Guides for diagnosing and resolving gas furnace operational problems.
Common electric motor issues, causes, and solutions.
Diagnosing problems with variable speed drives and belts.
Outlines the scope of the guide for Fanwall Technology units.
General description of FWR/FWT Fanwall Technology and its benefits.
Defines warranty coverage, limitations, and exclusions for FWR/FWT models.
Important safety precautions for installing and servicing equipment.
Covers electrical codes and installation clearances for FWR/FWT units.
Covers electrical connections and wiring requirements for FWR/FWT units.
Step-by-step guide for retrofitting FWR/FWT fanwall assemblies.
Routine checks for motors and fan alignment.
Checks for motor bearings and fan wheel cleanliness.
Lubrication of damper bushings and linkage.
Inspection of unit housing for corrosion.
Guide for replacing fan wheel and motor assemblies in FWR/FWT units.
Procedure for aligning fan wheels and cones on FWR/FWT units.
Instructions for installing and servicing backdraft dampers on FWR/FWT units.
Procedure for installing and removing blank-off plates on FWR/FWT units.
General inspection and maintenance for FWR/FWT unit motors.
Checks for physical condition and basic mechanical operation of the unit.
Verification of electrical connections, voltages, and component operations.
Troubleshooting fanwall start and run problems, motor issues.
Diagnosing motor failure, overheating, and voltage problems.
Addressing fan capacity, vibration, noise, and airflow problems.
