Tenda N300 Wi-Fi xPON ONT - Page 10

Get to know your device
2
LED indicator
Color
Status
Description
Off
No Ethernet device is connected or the Ethernet device is not
connected to any LAN port properly.
WLAN
Green
Solid on
The Wi-Fi network is enabled, but no data is being transmitted
wirelessly.
Blinking
slowly
(0.5s)
The Wi-Fi network is enabled, and data is being transmitted
wirelessly.
Blinking
quickly
(0.25s)
The ONT is performing or pending for WPS negotiation.
Off
The Wi-Fi network is disabled.
◼ Ports & buttons
Port/Button
Description
WPS/RST
WPS/Reset button.
⚫
WPS: Wi-Fi-enabled devices can connect to the Wi-Fi networks of the ONT
without entering the password through WPS negotiation.
Press the button for 1 to 3 seconds to start the WPS negotiation process of the
ONT. The WLAN LED indicator blink quickly. Within 2 minutes, enable the WPS
function on a WPS-supported device to establish a WPS connection.
⚫
Reset: Restore the ONT to the configurations preset by the ISP.
After the ONT completes startup, press the button for more than 10 seconds
and release it. All LED indicators will light off in a few seconds. When the PWR
LED indicator lights solid on again, the ONT is restored to the configurations
preset by the ISP.
PON
Optical fiber port.
Used to connect to a fiber cord.
LAN1-GE/LAN2
LAN1-GE: 1000 Mbps LAN port
LAN2: 100 Mbps LAN port
Used to connect to a router, switch, computer or IPTV set-top box.
PWR
Power jack.
Please use the included power adapter to connect the ONT to a power source.