Tenda N300 Wi-Fi xPON ONT - Customize the Main Wi-Fi Name; Enable Multiple Wireless Networks

WLAN
15
Parameter
Description
Radio Power (%)
You can set the intensity of the radio power of the ONT. A higher radio power brings a
wider coverage of Wi-Fi coverage.
Associated Clients
You can view the clients that connect to the Wi-Fi network by clicking Show Active WLAN
Clients.
⚫
MAC Address: It specifies the MAC address of the client connected to the Wi-Fi
network.
⚫
Tx Packets: It specifies the number of transmitted packets of the client through the Wi-
Fi network.
⚫
Rx Packets: It specifies the number of received packets of the client through the Wi-Fi
network.
⚫
Tx Rate (Mbps): It specifies the transmitting rate of the Wi-Fi network.
⚫
RSSI: It specifies the signal strength of the client received by the AP.
5.1.2 Customize the main Wi-Fi name
Step 1 Choose WLAN > Basic Settings on the web UI.
Step 2 Set SSID.
Step 3 Click Apply Changes.
---End
After completing the configuration, you can search the SSID(s) on your Wi-Fi-enabled devices and
connect to it to access the internet.
5.1.3 Enable multiple wireless networks
Step 1 Choose WLAN > Basic Settings on the web UI.
Step 2 Click Multiple AP. Select Enable to enable any Wi-Fi network as required, set SSID (Wi-Fi
name), and click Apply Changes.
*