Tenda N300 Wi-Fi xPON ONT - Page 99

Admin
91
Parameter
Description
End IP Address
ServiceName
It specifies the protocol adopted by the traffic, or the types of traffic.
⚫
TELNET: Telnet is a protocol that provides a command line interface for communication
with a remote device or server, sometimes employed for remote management but also
for initial device setup like network hardware.
⚫
HTTP: Hypertext Transfer Protocol (HTTP) is an application protocol and the foundation
of data communication for the World Wide Web, where hypertext documents include
hyperlinks to other resources that the user can easily access.
⚫
HTTPS: Hypertext Transfer Protocol Secure (HTTPS) is an extension of HTTP. SNMP is
used for secure communication over a computer network, and is widely used on the
Internet.
⚫
PING: Ping is a computer network administration software utility used to test the
reachability of a host on an IP network.
WAN
It specifies the interface to which the rule applies. It changes as you choose an interface.
LAN
ACL Table
It displays all the ACL rules that are added.
Select
It is used to select multiple ACL rules.
State
It specifies the control mode of the rule. If you deselect Enable when setting an ACL rule,
the State shows Disable.
Interface
It specifies the interface that the access control rule applies to, including LAN and WAN.
IP Address
It specifies the IP address range or a certain IP address that is controlled by the rule.
Services
It specifies the protocols adopted by the traffic, or the types of traffic.
Port
It specifies the default ports adopted by the corresponding services.