TensCare Kegel Toner User Manual (English)

Questions and Answers:

M
Megan MosleyJul 28, 2025
Why TensCare Kegel Toner have no sensation and no LEADS alarm showing?
- J
  James JohnsonJul 29, 2025
  If you experience no sensation and there's no LEADS alarm showing with your TensCare Personal Care Products, ensure the intensity level is adequately high. Most individuals typically begin to perceive stimulation around 25 mA when testing on their hand. When using the Kegel Trainer, you may need to increase the intensity to approximately 40 mA – 60 mA. Remember that everyone's sensitivity varies, so gradually increase the intensity until you can feel the stimulation. The maximum power is 99 mA.
J
Jennifer CrosbyAug 2, 2025
What to do if TensCare Kegel Toner have no sensation and LEADS alarm is showing?
- M
  montgomerykristenAug 2, 2025
  If your TensCare Personal Care Products display no sensation and the LEADS alarm is active, it could indicate a break in one of the lead wires. Test the unit by holding the Kegel Trainer in your hand. Dampen your hand with water and a little table salt, squeeze the Kegel Trainer firmly ensuring your skin covers the metal parts. Carefully increase the strength until you feel something. Most people will start to feel the stimulation in their hand at around 25 mA. The lead wires may need replacement.
A
Alejandro FlowersAug 7, 2025
How to fix TensCare Kegel Toner with no display?
- L
  Lisa Luna DDSAug 7, 2025
  If your TensCare Personal Care Products unit has no display, here are a few things to check: * **Flat batteries:** Replace the batteries. * **Incorrect battery insertion:** Remove the plastic wrap and verify that the batteries are inserted with the correct polarity (+/-). * **Damaged springs:** If the springs in the battery compartment are damaged, contact the supplier.
J
Jane JacksonAug 12, 2025
Why TensCare Kegel Toner Personal Care Products have no sensation on one side of the Kegel?
- T
  Taylor MartinezAug 12, 2025
  If you're experiencing no sensation on one side of the Kegel with your TensCare Personal Care Products, consider these potential causes: * **Dry skin:** Dry skin can reduce conductivity. If this enables you to use the unit, you should find that in a few weeks of stimulation the contact improves. * **Insufficient intensity:** Ensure the intensity level is high enough. * **Suboptimal position:** Adjust the position of the Kegel Trainer or try swapping the wire connections.
H
hughesmichelleAug 17, 2025
How to fix TensCare Personal Care Products that won’t work?
- J
  Jacqueline VargasAug 17, 2025
  If your TensCare Personal Care Products unit isn't working, try the following: * Press and hold the 'P' button for at least 5 seconds. * Remove and then replace the batteries.