Teraoka DS-650E - Maintenance Mode; SPAN Switch and Software Version Check; SPAN Adjustment

DS650E SERVICE MANUAL
4. Maintenance Mode
4.1. SPAN Switch and Software Version Check
1 - ZERO 2 - NET 3 - MEMORY 4 - BATTERY
OPERATION WEIGHT U.PRICE T.PRICE 1 2 3 4 REMARKS
0.0 0 0 0. 0 0 0.0 0 Weighing mode.
[RE-ZERO] 8 8 8 8 8 8 8 8 8 8 8 8 8 8 8 8 Enter 2 8 4 while pressing
[RE-ZERO] + [2] [8] [4] S t E 1 9 V r x. x x S - O N [RE-ZERO].
Display software ID code in weight column,
version in unit price column. Display S-ON in
total price column when SPAN switch is set to
enable, Can access to 142 and calibration
mode.
S t E 0 8 V r x. x x S - O F F Display S-OFF when SPAN switch is set to
disable. Can not access to 142 and calibration
mode.
0.0 0 0 0.0 0 0.0 0 Goes back to Weighing mode after 3 seconds
display.
4.2. SPAN Adjustment
1 - ZERO 2 - NET 3 - MEMORY 4 - BATTERY
OPERATION WEIGHT U.PRICE T.PRICE 1 2 3 4 REMARKS
0.0 0 0 0. 0 0 0.0 0 Weighing mode.
[RE-ZERO] 8 8 8 8 8 8 8 8 8 8 8 8 8 8 8 8 Enter 8 7 1 5 while pressing
[RE-ZERO] + [8] [7] [1] [5] C A L 0 0 RE-ZERO.
Ensure no weight on platter, [*] - - - - - Calibrating zero point.
:
:
:
Put full capacity weight on platter C A L S P
(e.g. 15kg), [*] - - - - - Calibrating Span.
After calibration 1 5.0 0 0 0.0 0 0.0 0 Goes back to Weighing mode.