Terex Genie Z-60/37 DC User Manual

Service and Repair Manual
Serial Number Range
Z
®
-60/37 DC
from Z6016N-101 to
Z6016N-
599
from Z60N-
600
This manual includes:
Repair procedures
Fault Codes
Electrical and
Hydraulic Schematics
Z
®
-60/37 FE
For detailed maintenance
procedures, refer to the
appropriate Maintenance
Manual for your machine.
Part No. 1271125GT
Rev A6
December 2018

Terex Genie Z-60/37 DC Specifications

General

Turntable Rotation	355° Non-continuous
Platform Rotation	160°
Vertical Jib Rotation	135°
Fuel Type	Electric
Horizontal Reach	11.15 m
Lift Capacity	227 kg
Platform Size	30 x 48 in (0.76 x 1.22 m)
Machine Width	7 ft 10 in
Machine Length	8.15 m
Drive Speed - Stowed	6.4 km/h
Power Source Voltage	48 V DC
Tire Type	Solid
Overall Length	8.15 m
Overall Width	7 ft 10 in

Summary

Introduction

Important Information

Details on safety, operating instructions, and qualified service professionals.

General Safety Guidelines

Safety Precautions

Critical safety rules and warnings for machine operation and maintenance.

Performance Specifications

Engine Specifications

Repair Procedures

Safety and Preparation

Essential safety rules and pre-repair checks before starting maintenance.

Calibration Procedures

Calibration Process Steps

Sequential steps for calibrating system defaults and sensors.

Platform Controls and Adjustments

Control Box Components and Settings

Platform Overload System

System Calibration and Fault Reset

Procedures for calibrating the overload system and resetting faults.

Primary Boom Components

Cable Track and Boom Service

Troubleshooting Fault Codes

Fault Code Reference

Detailed list of control system fault codes, causes, effects, and solutions.

System Navigation

Menu Navigation Overview

Schematics Overview

Wiring Diagrams

Detailed Electrical Schematics

Control Box Wiring Diagrams