3 Technical data
26 TL80
3.5 Brakes
Service brake Hydraulically actuated center-mounted disk brake, combined with
hydrostatic brake of travel drive.
Brake acts on all 4 wheels via 4-wheel drive.
Parking brake Mechanically actuated center-mounted disk brake at front axle.
Additional brake The hydrostatic travel drive in closed circuit additionally acts as
non-wearing service brake.
3.6 Hydraulic system
Hydraulic pump Gear pump on throughdrive of variable displacement pump.
Pump capacity: max. 64 l/min.
Working pressure, steering: 175 bar
Working pressure, loading: 250 bar
Priority valve Priority supply of hydraulic oil to steering through load-sensing
system, ensuring that all the available oil can be provided if
necessary. Rapid steering movements even at low engine revs.
Steering Fully hydraulic, proportionally acting articulated steering.
One double-acting steering cylinder.
Total steering angle 80°
Loader frame
Parallel kinematics
Double-acting work cylinders, one lift cylinder and one tilt cylinder.
Z kinematics
Double-acting work cylinders, two lift cylinders and one tilt
cylinder.
Control valve with 3 control circuits.
Electro-hydraulically operated float position for "Lower" work
function.
Single, four-way control lever (joystick) with integrated direction-of-
travel switch, float position switch and switch for additional control
circuit.
Additional control circuit Max. oil flow 64 l/min
Max. operating pressure 230 bar
Hydraulic oil cooler Thermostatically controlled.
To Next Page
Loading...
Need help?
General
