TERMA MOA BLUE - Installation and Preparation; Installation and First Use Procedures

11
EN
Installaon or removal
Detailed informaon demonstrang the dif-
ferent ways of installing or removing a radi-
ator heang element is available from the
manufacturer or importer (see footnotes at
the end of the manual). Below we list some
basic requirements and principles which
must be followed to ensure long term, reli-
able operaon of the product.
150°
When the heang element is installed hori-
zontally, it must be rotated to such an extent
that the single tube, which houses the temper-
ature sensor, is posioned as low as possible.
Before installaon or rst use:
1. Read the chapter Safety requirements
– Installaon.
2. Fit the heang element using the cor-
rect spanner (size 22).
3. The heang element must be installed
at the boom of the radiator, perpen-
dicular to the radiator pipes, while pre-
serving space for the proper circulaon
of the heang medium.
4 Use a suitable heang medium for ll-
ing the electric radiator, i.e. (water, spe-
cial products based on water and glycol
for use in central heang systems, or oil
which complies with the requirements
of the manufacturer of the radiator and
heang element).
5. DO NOT SWITCH THE HEATING ELEMENT
ON IF IT IS NOT FULLY IMMERSED IN
RADIATOR HEATING MEDIUM (APPLIES
ALSO TO THE FIRST USE)!
6. Make sure an adequate air cushion is pre-
sent to protect against excessive pressure
build up within the electric only radiator
(or leave one of the radiator valves open
in central heang system).
7. When lling the radiator with hot liquid
insure that the liquid temperature does
not exceed 65° C.
8%
(
20° C
)