OPERATION
1-2
Page 9
ML50-20 MAINTENANCE LIFT
TESCO EQUIPMENT LLC
E. Stabilizer Control Station
(Ref. Figure 6)
(1) STABILIZER RETRACT – black push button switch. When depressed, returns stabilizers
to stowed position.
(2) STABILIZER EXTEND – black push button switch. When depressed, the stabilizers are
deployed so that the platform can be raised.
NOTE: All stabilizers must be fully extended before raising lift.
Figure 6
STABILIZER CONTROL STATION
5. HI-LIFT VEHICLE OPERATING PROCEDURE
A. Preliminary Checks
The following preliminary check list shall be performed before driving the vehicle.
(1) FUEL LEVEL – DO NOT operate vehicle if fuel level is below ¼ tank.
(2) WHEEL BRAKES – DO NOT operate vehicle if the service brake pedal is resting low near
the floorboard or if brake pedal is spongy when brake is applied.
(3) TIRES – DO NOT operate this vehicle if tire pressure is low.
(4) OIL LEVEL – Visually check the level of the hydraulic oil on the hydraulic oil reservoir’s
sight gauge.
(5) GENERAL CONDITION – Perform a general walk around visual inspection of the vehicle’s
overall condition. DO NOT operate vehicle or Hi-Lift if any damage to the vehicle or
structure is seen.
1
2
Jan. 14
Property of American Airlines
To Next Page
Loading...