Tesla CYBERTRUCK - Shifting

Shift Using the Touchscreen
When you press the brake pedal when Cybertruck is
parked, the drive mode strip displays on the driver's side
of the touchscreen. Use the drive mode strip to shift
Cybertruck: Swipe up for Drive, swipe down for Reverse,
or press the drive mode strip for Park.
The touchscreen always shows which gear Cybertruck is
in, but the drive mode strip is hidden when driving at
highway speeds. To show the drive mode strip at any
time, swipe right from the left edge of the touchscreen.
To shift into Park when driving below 5 mph (8 km/h),
touch the drive mode strip while pressing the brake
pedal. In emergency situations when driving above 5
mph (8 km/h), press and hold the gear strip to slowly
bring the vehicle to a stop.
NOTE: To shift from Drive into Reverse or vice versa, the
driving speed must be less than 5 mph (8 km/h).
The touchscreen is the preferred method to manually
shift. However, in the unlikely situation in which the
touchscreen is unavailable and therefore can't be used,
the drive mode selector on the overhead console
automatically activates and must be used to shift (see
Shift Using the Overhead Console on page 75).
If you try to shift when it is prohibited by the current
driving speed, the touchscreen displays an alert, a chime
sounds, and the drive mode does not change.
Auto Shift out of Park
Auto Shift out of Park is a BETA feature and is disabled
by default. When disabled, use the touchscreen or the
overhead console to manually shift. To enable Auto Shift
out of Park, touch Controls > Dynamics > Auto Shift out
of Park.
When Auto Shift out of Park is enabled, Cybertruck is
designed to automatically select Drive or Reverse. The
touchscreen displays the selected drive mode when the
driver's door is closed and seat belt is buckled.
To override the selection, press the brake pedal and use
the drive mode strip on touchscreen to shift into your
desired drive mode (Drive, Reverse, Park; see Shift Using
the Touchscreen on page 75).
Confirm the drive mode selection and follow the
instructions on the touchscreen before you press the
accelerator.
WARNING:
As always, be aware of your vehicle
and surroundings before driving. Never rely on
Cybertruck to automatically select a suitable drive
mode without confirming the selection before you
start to drive.
If Auto Shift out of Park is unavailable, the touchscreen
displays a message.
Cybertruck automatically selects a drive mode when:
•
Auto Shift out of Park is enabled.
•
Cybertruck is in Park.
•
The driver's seat belt is fastened.
•
The brake pedal is pressed.
•
All doors and trunks are closed.
•
The drive mode selector on the overhead console is
not activated (see Shift Using the Overhead Console
on page 75).
•
The cameras are free of obstructions (see Cameras
on page 26) and Cybertruck has enough input to
make a selection.
NOTE: Cybertruck does not automatically select drive
modes in Valet Mode.
Shift Using the Overhead Console
In addition to manually shifting on the touchscreen, you
can shift by pressing P, R, N or D located on the
overhead console. In most situations, these buttons are
not available until you press one of the buttons to
activate it. When active, the LEDs associated with each
button illuminate and when you select P, R, N or D, the
associated LED illuminates.
Shifting
75Driving