• A raised concrete edge is detected.
Summon does not move Model 3 over an
edge that is higher than approximately
2.5 cm.
• One or more of the ultrasonic sensors (if
equipped) or cameras is damaged, dirty,
or obstructed (such as by mud, ice, or
snow, or by a vehicle bra, excessive paint,
or adhesive products such as wraps,
stickers, rubber coating, etc.).
• Weather conditions (heavy rain, snow,
fog, or extremely hot or cold
temperatures) are interfering with sensor
operation.
•
The sensors (if equipped) are aected by
other electrical equipment or devices that
generate ultrasonic waves.
NOTE: Summon is disabled if Model 3 is in
Valet mode (see Valet Mode on page 51).
WARNING: The list above does not
represent an exhaustive list of
situations that may interfere with
proper operation of Summon. It is the
driver's responsibility to remain in
control of Model 3 at all times. Pay
close attention whenever Summon is
actively moving Model 3 and stay
prepared to take immediate action.
Failure to do so can result in serious
property damage, injury or death.
Summon
124 MODEL 3 Owner's Manual
To Next Page
Loading...
