Tesla MODEL 3 2012 - Smart Summon

NOTE: Depending on market region, vehicle
configuration, options purchased, and
software version, your vehicle may not be
equipped with Smart Summon, or the feature
may not operate exactly as described.
Smart Summon is designed to allow you to
move Model 3 to your location (using your
phone's GPS as a target destination) or to a
location of your choice, maneuvering around
and stopping for objects as necessary. Smart
Summon works with the Tesla mobile app
when your phone is located within
approximately 65 meters of Model 3. Smart
Summon maneuvers Model 3 out of parking
spaces and around corners. This is useful for
moving Model 3 out of a tight parking spot,
through puddles, or helping you retrieve your
car while carrying packages. You must
maintain a clear line of sight between you and
Model 3 and closely monitor the vehicle and
its surroundings at all times.
CAUTION: Ensure all cameras and
sensors are clean. Dirty cameras and
sensors, as well as environmental
conditions such as rain and faded lane
markings, can aect Autopilot
performance.
WARNING: Smart Summon is
designed and intended for use only on
parking lots and driveways located on
private property where the
surrounding area is familiar and
predictable. Do not use Smart
Summon on public roads.
WARNING: Smart Summon must only
be used on paved surfaces.
WARNING: Smart Summon is a BETA
feature. You must continually monitor
the vehicle and its surroundings and
stay prepared to take immediate
action at any time. It is the driver's
responsibility to use Smart Summon
safely, responsibly, and as intended.
WARNING: Smart Summon may not
stop for all objects (especially very
low objects such as some curbs, or
very high objects such as a shelf) and
may not react to all trac. Smart
Summon does not recognize the
direction of trac, does not navigate
around empty parking spaces, and
may not anticipate crossing trac.
WARNING: Smart Summon's
performance depends on the
ultrasonic sensors (if equipped), the
visibility of the cameras, and the
availability of an adequate cellular
signal and GPS data.
WARNING: When using Smart
Summon, you must maintain a clear
line of sight between you and Model 3
and stay prepared to stop the vehicle
at any time by releasing the button on
the mobile app.
Before Using Smart Summon
•
Download the latest version of the Tesla
mobile app to your phone, and ensure
your phone has cellular service and GPS
enabled.
•
Your phone must be connected to Model
3 and located within approximately 65
meters.
•
The vehicle's cameras must be fully
calibrated (see Drive to Calibrate Cameras
on page 93).
•
You must have a clear line of sight to
Model 3.
•
Model 3 must be in Park, not charging,
and all doors and trunks must be closed.
Using Smart Summon
1. Open the Tesla mobile app, and press
Summon.
2. Press the Smart Summon icon located in
the center of the image of your Model 3. It
may take several seconds for Smart
Summon to start up.
NOTE: You can use Standby Mode to
eliminate the delay that occurs when
Smart Summon is starting up (see
Standby Mode on page 127).
The mobile app displays a map with a
blue circle, which represents the
maximum proximity of
65 meters that you
must maintain between your phone and
Model 3. The blue dot on the map
represents your location, and the red
arrow represents the location of
Model 3.
Smart Summon
125Autopilot