Tesla MODEL 3 2012 - Wiper Blades and Washer Jets

Checking and Cleaning Wiper
Blades
Periodically clean the edge of the wiper
blades and check the rubber for cracks, splits,
and roughness. If damaged, replace the blade
immediately to prevent damage to the glass
and improve visibility.
Contaminants on the windshield, or on the
wiper blades, can reduce the eectiveness of
the wipers. Contaminants include ice, wax
spray from car washes, washer
fluid with bug
and/or water repellent, bird droppings, tree
sap, and other organic substances.
Follow these guidelines for cleaning:
•
Clean the windshield and wiper blades
using washer fluid, isopropyl (rubbing)
alcohol, or non-abrasive glass cleaner
approved for use on automotive glass and
rubber. Inappropriate products can cause
damage or smears, and create glare on
the windshield.
•
Lift the wiper arm a short distance away
from the windshield, just far enough to
access the wiper blade. Do not lift a wiper
arm beyond its intended position.
If the wipers remain ineective after cleaning,
replace the wiper blades.
Replacing Wiper Blades
For optimum performance, replace the wiper
blades at least once a year. Replacement
blades must meet the following criteria:
•
The blade on the driver's side must be
650 mm long and 475 mm long for the
blade on the passenger's side.
• Ensure the connector on the replacement
blade is the same as the original blade.
Dierent connectors may prevent the
replacement blade from connecting to
the wiper arm on the vehicle.
You can purchase replacement wiper blades
on http://www.tesla.com.
NOTE: Only install replacement blades that
are identical to the original blades. Using
inappropriate blades can damage the wiper
system and windshield.
To replace the wiper blades:
1. Shift into Park and turn
o the wipers.
2. Touch Controls > Service > Wiper Service
Mode > ON to move the wipers to the
service position.
3. Lift the wiper arm a short distance away
from the windshield, just far enough to
access the wiper blade.
CAUTION: Wiper blades do not
lock into a lifted position. Do not
lift a wiper arm beyond its
intended position.
4. Place a towel between the wiper arm and
windshield to avoid scratching or cracking
the windshield.
5.
Hold the wiper arm and press the locking
tab while sliding the blade down the arm.
6.
Align the new wiper blade on the wiper
arm and slide it toward the end of the
wiper arm until it locks into place.
7. Turn Wiper Service Mode o to return the
wipers to their normal position.
Cleaning Washer Jets
If a windshield washer becomes blocked, use
a thin strand of wire to clear any blockages
from the nozzles.
Wiper Blades and Washer Jets
209Maintenance