Asymmetric Tires
Model 3 tires are asymmetric and must be
mounted on the wheel with the correct
sidewall facing outward. The sidewall of the
tire is marked with the word
OUTSIDE. When
new tires are installed, make sure that the
tires are correctly mounted on the wheels.
WARNING: Road holding is seriously
impaired if the tires are incorrectly
installed on the wheels.
Removing and Installing Aero Covers
If your Model 3 is equipped with aero covers,
you must remove them to access the lug nuts.
To remove an aero cover:
1.
Grasp the aero cover firmly with both
hands.
2.
Pull the aero cover toward you to release
the retaining clips.
To install an aero cover:
1. Align the aero cover into position so that
the notch at the base of the Tesla "T" is
aligned with the tire's valve stem.
2.
Push firmly around the perimeter of the
aero cover until it fully snaps into place.
CAUTION: To prevent the aero
cover from falling o, ensure that
it is fully secured before driving.
Removing and Installing Lug Nut
Covers
If your Model 3 is equipped with lug nut
covers, you must remove them to access the
lug nuts.
To remove a lug nut cover:
1.
Insert the curved part of the lug nut cover
tool, if equipped (located in the glovebox
in some vehicles, or you can use a small
allen wrench) into the hole at the base of
the Tesla "T".
NOTE: The lug nut cover tool can also be
purchased at an auto parts store or
through online retailers.
2. Maneuver the lug nut cover tool so that it
is fully inserted into the hole in the lug nut
cover.
Tire Care and Maintenance
200 MODEL 3 Owner's Manual
To Next Page
Loading...
