CAUTION: Brake fluid damages
painted surfaces. Immediately soak up
any spills with an absorbent cloth and
wash the area with a mixture of car
shampoo and water.
Topping Up Windshield Washer
Fluid
The only reservoir into which you can add
fluid is the windshield washer fluid reservoir,
which is located behind the front trunk. When
the level is low, a message displays on the
touchscreen.
To top up the washer fluid:
1.
Open the hood.
2.
Clean around the filler cap before opening
it to prevent dirt from entering the
reservoir.
3.
Open the filler cap.
4.
While avoiding spilling, fill the reservoir
until the fluid level is visible just below the
filler neck. The reservoir has a capacity of
3.2 liters.
5.
Wipe up any spills immediately and wash
the
aected area with water.
6. Reinstall the filler cap.
NOTE: Some national or local regulations
restrict the use of Volatile Organic
Compounds (VOCs). VOCs are commonly
used as antifreeze in washer
fluid. Use a
washer
fluid with limited VOC content only if
it provides adequate freeze resistance for all
climates in which you drive Model 3.
CAUTION:
Do not add formulated
washer fluids that contain water
repellent or bug wash. These fluids
can cause streaking, smearing, and
squeaking or other noises.
WARNING:
In temperatures below
4° C, use a washer fluid with
antifreeze. In cold weather, using a
washer fluid without antifreeze can
impair visibility through the
windshield.
WARNING:
Windshield washer fluid
can irritate eyes and skin. Read and
observe the instructions provided by
the washer fluid manufacturer.
Fluid Reservoirs
212 MODEL 3 Owner's Manual
To Next Page
Loading...
