5. Connect the low voltage power supply's
black negative (-) cable to the black
negative (-) terminal on the low voltage
battery.
6.
Turn on the external power supply (refer
to the manufacturer’s instructions). Touch
the touchscreen to wake it up.
NOTE: It may take several minutes to
receive enough power to wake up the
touchscreen.
7.
When external low voltage power is no
longer required, disconnect both cables
from the terminals on the battery,
beginning with the black negative (-)
cable.
8.
Reinstall the cabin intake trim panel by
placing it back in its original location and
pressing down until it is secure.
9. Replace the maintenance panel by placing
it back in its original location and pressing
down until it is secure.
10.
Close the hood.
Jump Starting the Low Voltage
(Lithium-Ion) Battery
1. Open the hood (see Opening Hood with
No Power on page 19).
2. Remove the maintenance panel by pulling
it upwards to release the trim clips that
hold it in place.
3. Remove the red cover and connect the
external low voltage power supply’s red
positive (+) cable to the red positive (+)
jump post.
CAUTION: To avoid damaging the
vehicle, do not allow the positive
cable to contact other metal
components.
4.
Connect the external low voltage power
supply’s black negative (-) cable to the
bolt located between the brake
fluid
reservoir and the front trunk. The bolt is
used as a grounding location for the
external support.
5.
Turn on the external power supply (refer
to the manufacturer’s instructions) for
20-30 seconds.
Instructions for Transporters
237Roadside Assistance
To Next Page
Loading...
