Tesla Model 3 - Page 107

• From outside the vehicle, initiate the parking
maneuver by touching Summon on the mobile app,
then holding down the FORWARD or REVERSE
button.
NOTE: If the Require Continuous Press setting is NO,
you do not need to hold down the button, just press
and release.
NOTE: You can also initiate the parking maneuver
from inside the vehicle (see
Starting Summon Before
Exiting the Vehicle on page 105).
Summon shifts Model 3 into Drive or Reverse (based on
the direction you specified) and drives into or out of the
parking space. When parking is complete, or if an
obstacle is detected, Summon shifts
Model 3 into Park.
Summon shifts Model 3 into Park when:
• Model 3 detects an obstacle in its driving path (within
the Bumper Clearance setting that you specified).
•
Summon has moved Model 3 the maximum distance
of 39 feet (12 meters).
•
You release the FORWARD or REVERSE button
(when Require Continuous Press is turned on).
•
You press any button to manually stop Summon.
If you used Summon to park Model 3, you can then use
Summon to return Model 3 back to its original position
(provided the vehicle has remained in Park), or to the
maximum Summon Distance that you have specified
(whichever comes first). Simply specify the opposite
direction on the mobile app and Summon moves the
vehicle along the original path, provided no obstructions
have been introduced. If the ultrasonic sensors detect an
obstacle, Summon attempts to avoid the obstacle while
staying very close to its original path (Summon does not
steer around obstacles).
NOTE: To move Summon multiple times in the same
direction (not to exceed the maximum of 39 feet (12
meters), cancel Summon and then restart the parking
process using the same direction.
NOTE: Although Summon can move Model 3 a short
distance laterally to avoid an obstacle, it does not
attempt to steer around an obstacle to return the vehicle
to its original driving path.
Only Smart Summon (if
equipped) can steer the vehicle around objects.
NOTE: If you release the direction button on the mobile
app, Summon stops moving Model 3.
NOTE: Summon requires that Model 3 can detect a valid
key nearby.
NOTE: Summon requires that Model 3 can detect an
authenticated phone nearby
(Canada only).
WARNING:
Model 3 cannot detect obstacles that
are located lower than the bumper, are very
narrow, or are hanging from a ceiling (for example,
bicycles). In addition, many unforeseen
circumstances can impair Summon's ability to
move in or out of a parking space and, as a result,
Summon may not move Model 3 appropriately.
Therefore, you must continually monitor the
vehicle's movement and its surroundings and
remain prepared to stop Model 3 at any time.
Operating Summon with the Key
NOTE: Using the key to operate Summon is available
only in the United States.
NOTE: Summon may not operate if the key fob
accessory's battery is low.
Follow these steps to park Model 3 from outside the
vehicle using the key fob accessory:
1.
On the touchscreen, ensure that Require Continuous
Press is disabled (touch Controls > Autopilot >
Summon > Require Continuous Press > NO).
2.
With Model 3 in Park, stand within 10 feet (3 meters)
and press and hold the top center button on the key
fob accessory (Lock/Unlock All button) until the
hazard lights blink continuously.
NOTE: The hazard lights flash once as Model 3 locks,
then within five seconds, Model 3 powers on and the
hazard lights
flash continuously. Do not proceed to
the next step until the hazard lights are flashing. If,
after five seconds, the hazard lights are not flashing,
release the button on the key fob accessory, move
closer to Model 3, and try again. If Summon receives
no further input within ten seconds, Summon cancels.
3.
Press the Front Trunk button on the key fob
accessory to move Model 3 forward into the parking
space, or press the Rear Trunk button to reverse
Model 3 into the parking space.
Starting Summon Before Exiting the
Vehicle
To start a Summon parking sequence before exiting
Model 3:
1.
On the touchscreen, ensure that Require Continuous
Press is disabled (touch Controls > Autopilot >
Summon > Require Continuous Press > NO).
2.
Close all doors and trunks.
3.
With Model 3 powered on and the Park gear
engaged, double press the Park button on the drive
stalk. The touchscreen displays a popup window.
4. On the touchscreen, choose the direction of travel.
5.
Exit Model 3 and close the driver's door.
Summon
105Autopilot