Chapter 2 – Receiving and Installation
TestEquity FS Series Ovens Page 2-1
Chapter 2 – Receiving and Installation
Your satisfaction and safety require a complete understanding of this unit. Read the instructions
thoroughly and be sure that all users are given adequate training before attempting to use this
unit. Note: This equipment must be used only for its intended purpose; any alterations or
modifications will void your warranty.
Inspection
The carrier, when accepting shipment, also accepts responsibility for safe delivery and is liable
for loss or damage claims. On delivery inspect for visible exterior damage, note and describe on
the freight bill any damage found and enter your claim on the form supplied by the carrier.
Inspect for concealed loss or damage on the unit itself, both interior and exterior. If any, the
carrier will arrange for official inspection to substantiate your claim.
Verify that your accessory package is complete. All units should have a set of four (4) Leveling
feet, two (2) shelves and eight (8) shelf clips.
Return Shipment
Save the shipping crate and all packaging material until you are sure the oven has not been
damaged and is functioning correctly. If for any reason you must return the unit, contact your
customer support representative for authorization and supply data plate information. Make sure
to include the model and serial number. The service representatives will furnish you with a return
authorization number and address for return. Note: Make sure this return authorization number
appears on the unit packaging and shipping papers. Units returned without proper authorization
may not be accepted at the factory. For information on where to contact customer support please
see the manual cover.
Installation
Local city, county or other ordinances may govern the use of this equipment. If you have any
questions about local requirements, please contact the appropriate local agency. Installation may
be performed by the end user.
This unit is intended for use indoors, at room temperatures between 5° to 40°C (41° to 104°F), at
no greater than 80% Relative Humidity (at 25°C/77°F) and with a supply voltage that does not
vary by more than ±10%. Customer support should be contacted for operating conditions outside
these limits.
To Next Page
Loading...