TESTO 410-2 Short Manual

Product description14
Product description
At a glance
À Protection cap: Park position
Á Impeller
 Humidity/temperature sensor
à Display
Ä Control keys
Å Battery compartment (on rear)
First steps
ã Inserting batteries:
1 To open the battery compartment, push the battery cover
down.
2 Insert batteries (2x 1.5 V type AAA). Observe the polarity!
3 To close the battery compartment, push the battery cover
back on.
ã Basic settings (configuration mode):
Adjustable functions
· Unit of temperature: °C, °F
· Unit of humidity: %, td (dew point), WB (wet bulb)
· Unit of velocity: m/s, km/h, fpm, mph, kts, Beau
· Auto off function: OFF, ON (instrument switches off automatically if no key is
pressed for 10 minutes)
1 When switching the instrument on, press and hold until
and appear on the display (configuration mode).
- The adjustable function is displayed. The current setting
flashes.
2 Press ( ) several times until the desired setting flashes.
3 Press ( ) to confirm the input.
4 Repeat steps 2 and 3 for all functions.
- The instrument changes to measuring mode.

TESTO 410-2 Specifications

General

Measurement Parameters	Air velocity, Temperature, Humidity
Air Velocity Range	0.4 to 20 m/s
Temperature Range	-10 to +50 °C
Humidity Range	0 to 100 %RH
Resolution (Air Velocity)	0.1 m/s
Resolution (Temperature)	0.1 °C
Resolution (Humidity)	0.1 %RH
Accuracy (Temperature)	±0.5 °C
Display	LCD
Power Supply	2 x AAA batteries
Operating Temperature	-10 to +50 °C
Storage Temperature	-20 to +70 °C
Dimensions	133 x 46 x 25 mm
Units	m/s, °C, %RH
Measuring Principle	Vane anemometer