TESTO 416 - Setting the Area; Carrying out a Reset of the Setting Menus; Carrying out a Reset of the Measuring Instrument

7 Using the product
14
3
Press ◄ / ► to set the required unit for the bottom line (m
3
/h, l/s, cfm)
and confirm with MENU/ENTER.
7.1.4 Setting the area

Configuration mode is open, “AREA” is displayed.
1
Press ◄ / ► to select whether the cross-sectional area is to be
entered in m² or in mm² and confirm with MENU/ENTER.
2
Press ◄ / ► to set the cross-sectional area and confirm with
MENU/ENTER.
The measuring instrument can show a maximum of 5 digits in the
display (99999 mm²). Conversions from m² to mm² with a value greater
than 0.09 m² are therefore not possible!
7.1.5 Carrying out a reset of the setting menus

Configuration mode is open, “M. RES” (menu reset) is displayed.
1
Press ◄ / ► to select the required option and confirm with
MENU/ENTER:
o NO: Do not carry out reset.
o YES: Carry out reset. All concealed menus that were hidden
via the testo Smart App are displayed again.

The instrument returns to measurement view.
7.1.6 Carrying out a reset of the measuring
instrument

Configuration mode is open, “RESET” is displayed.
1
Press ◄ / ► to select the required option and confirm with
MENU/ENTER:
o NO: Do not carry out reset.
o YES: Carry out reset. The instrument is reset to the factory
settings.

The instrument returns to measurement view.