42
Timed mean calculation
The duration of the measurement from which the mean is to be calculated must be input first for
the timed mean calculation (1 to 60 s, or 1 to 60 min).
The current measured value appears after is pressed. and are available as
function buttons. starts a timed mean calculation for the specified duration (see time in top
left of display). interrupts the procedure. If is pressed the mean calculation is
extended by the values resulting from the longer lasting measurement. opens a new log,
the values measured up to now are not used. You can leave the mean calculation function by
pressing again.
Multi-point mean calculation
Each time the function button is pressed a value for the arithmetic mean calculation is
stored. The value counter at the top left increases accordingly. adds the measured
values together and the end value is divided by the number of measured values. You can leave the
mean calculation function by pressing again.
If is pressed new measured values are added to the old values (See value counter).
erases the values counter and opens a new log. The values are stored in the memory.
You will find the calculated mean under .
Timed multi-point mean calculation
This function is a combination of the mean calculations described above: a multi-point arithmetic
mean calculation in which the mean is calculated at each respective point over a specified length of
time. The duration and the value counter are located in the top left corner of the display.
Timed, graphic mean calculation
This function takes the values measured over a period of up to 90 s and displays them in the form
of a graph. and control the process, extends the procedure by an
additional extended measurement. switches to other measuring channels. in
this window closes the graph.
End
ContinueEndStart
Info
New
Continue
End
End
Start
End
New
Continu eEnd
Start
EndStart
Mean calculation options
Velocity measurement
To Next Page
Loading...
