TESTO 922 - Displaying and Adjusting Readings

8 Controls via testo Smart App
27
2
Click on Average of the measured values.

The window for Average of the measured values opens.
3
Enter a value between 2 and 20 measured values.

Changes to the measuring instrument settings in the app are
transferred directly to the measuring instrument. Synchronization with
the app is confirmed on the measuring instrument via “SYNC DONE”.
8.4.4
Configuring alarms

The standard view with the LIVE tab is open.
1
Click on .
2
Select Alarm configuration.

The menu with the overview of alarms that can be activated opens.
3
Click on the checkbox to activate a specific alarm.
4
Click on EDIT.

The input window for activating and defining upper and lower warning
and alarm values is displayed.
5
Click OK to confirm the settings.

Changes to the measuring instrument settings in the app are
transferred directly to the measuring instrument. Synchronization with
the app is confirmed on the measuring instrument via “SYNC DONE”.
8.4.5
Setting the surface increment
Surface probes withdraw heat from the measured surface immediately
after the initial contact. As a result, the measurement result is lower
than the actual surface temperature without the probe (the reverse is
true for surfaces that are colder than the probe). This effect can be
corrected by an increment in % of the reading.

The Settings tab is open.
1.888.610.7664 sales@GlobalTestSupply.com
www.Testo-Direc t.com