TESTO 945 - Page 31

5. Device control
31
Duration
Select program duration: .
· No. oof mmeasuring ccycles:
Number of measurements to be carried out and
which are to be saved within the measurement
program.
·
Unit mmemory iis ffull:
Measurement stops if the instrument memory is
full
Measuring rate
Setting measuring rate:
· Enter value
· Enter unit: .
Measurement program comes into effect
1
Confirm input: .
2
Confirm
Instrument has been successfully
programmed
message: .
5.2.2 Starting measurement program
PC Start:
Starting program: .
Program is finished once the measurement has run
through.
Starting the instrument:
Starting the measurement program: .
Program is finished once the set measurement
program has run through.
End measurement program manually:
1
Stop program: .
2
Confirm
Interrupt measurement mode
message: .
- Measurement protocol is listed under site.