4
Initial operation of instrument
Please read prior to operation
Do not measure on live parts.
Observe admissible storage and transport temperature as well as the operating temperature
(e.g. protect measuring instrument from direct sunlight).
Turn off the instrument when changing configurations (e.g. changing the probe) because the
characteristic values specific to the probe are only read by the instrument when switched on.
The V24 cable (barcode pen or PC connection) can be plugged in at any time.
If a PC cable is connected, a simultaneous print command is not possible.
Ensure that contacts are correct in probes with plug-on head.
Tighten the sleeve in the probe handle until the limit stop is reached.
The warranty is no longer valid if the instrument is opened, in the case of inexpert handling or
use of force.
Button cell - stores the
contents of the memory if
the rechargeable
batteries are empty or if
the battery is changed.
Testo rechargeable
battery
Putting in batteries
Unscrew the back of the measuring instrument. Place the button
cell (Part no.: 0515.0028) in the opened battery compartment
with the “+” pole on top and put in the batteries or the Testo
rechargeable batteries (Part no. 0554.0196). Observe
polarization! Close battery compartment.
You will find further information on alternative power supply,
recharging mode, battery quality, recharging in the “Power
supply“ chapter. Refer to the index.
i
Power supply
To Next Page
Loading...
Need help?
General
